Instructions for using liquid filters:

1. Installation base: Before installation, check the direction of the inlet and outlet clearly. The liquid should flow from the outside of the filter element to the center, and the pipeline connected to the filter element socket is the outlet. There are arrows indicating the flow direction on the filter pipeline, do not connect them incorrectly.

2. Installation of filter core: 22 ports are plug-in type; The 226 socket is a card in type. If it is a multi-core filter, the pressure plate should be placed on the fins and the bolts should be tightened appropriately (the filter core will elongate under high temperature, and if the pressure plate is too tight, the filter element will have no space for elongation, which will cause distortion and deformation, affecting the filtration accuracy).

3. Install the outer cover and seal it with clamps (single core) or bolts (multi-core) connected to the base. Pay attention to placing the sealing gasket flat and check that there is no leakage at the sealing point.

4. The filter is toxic, and the new grill must be cleaned thoroughly before use. The sterilization device used for disinfection should be disinfected and sterilized, and the disinfection work should generally be carried out during production to avoid external pollution. The disinfection of Yan steam should strictly control the pressure and pressure difference of Yan steam to avoid damaging the filter element due to excessive steam pressure and pressure difference.

5. When filtering liquids, the exhaust valve at the top of the filter should be opened first to exhaust the gas inside the cylinder and allow the liquid to fill the cylinder, otherwise it will affect the flow rate.

6. When the filter medium flows through the grill, it will experience a pressure drop due to resistance (the pressure difference between entering and exiting). To overcome this resistance, it is necessary to maintain sufficient shooting stars and, if necessary, sufficient working pressure. We provide corresponding temperature and pressure limit values for each filter element, please use them according to the requirements. To avoid excessive flow impact on the filter element, be sure to open the valve slowly!

7. When using a self selected pump, please pay attention to matching the flow rate and pressure. It is advisable to choose self-priming pumps such as vortex pumps and infusion pumps.

8. When shutting down, the filtered liquid should be drained. If the time is not long, the filter does not need to be opened; If the time is long or the filtrate is not suitable for long-term storage, the filter or filter element should be cleaned.